about the device
The Display Panel
There are four symbols on the display
- The brightness setting indicator shows you the level of brightness that you have selected. There are four settings to choose from.
- The battery charge symbol will show you how much battery life is left and will flash when the battery needs charging.
- The temperature indicator will only come on if the product has overheated. In this unlikely event the unit will cut out symbol will flash until Breastlight has cooled down sufficiently and it is ready again for use.
- The days since last used indicator shows how long ago you last used your Breastlight. You may find this useful as a reminder.
Batteries and power
Breastlight is powered by a set of rechargeable batteries. Before the first use they will need to be charged for 4 hours – after that recharging is faster.
If you are using the device with mains power please ensure the cables and power supply cannot get wet and take care not to trip over the cable.
The Light
Breastlight uses skin sensing technology to ensure that the light is only at full power when the lens is in contact with your skin. The skin sensor needs time to reset itself when you switch the Breastlight on, so wait for a couple of seconds before placing it against your skin.
Breastlight emits light in a visible wavelength. This is completely safe and will not cause any damage to your skin or breast tissue.
We advise you not to look directly into the light when it is at any of its bright settings. This will not cause any permanent damage but may cause a temporary dazzling effect.
Cleaning and care
Breastlight may be cleaned using a dry tissue or slightly damp cloth.
Breastlight is not a waterproof device. Breastlight should not be used in the shower or in the bath.
Environment
Do not throw the appliance away with the normal household waste at the end of its life but hand it to an official collection point for recycling. By doing this you will help to preserve the environment.
Always remove the battery before discarding the appliance Here are instructions on how to do this
